I'm at it again. Remember the wall? The wall and door chewed up and scratched away by our mischievous pups Tilly the Tall and Ebony the Short?
Well, this time it's the floor.
No, our loyal pups did not dig holes in the floor. That old self-stick composite tile is 30 years old.
It wore pretty well and used to look nice. Everything looks nice when it is new, doesn't it?
Some tiles loosened off a bit around the edges and pieces cracked away. It curled a bit in places too. Old stuff is enough to curl your hair and crack your mind sometimes.
We have to rip out the old composite tile and install new ceramic tile. By the time I'm finished this job, I will also be tired. Good thing I have a wonderful helper who is also the supervisor, planner, coffee-maker and cookie-baker.
See how nice this old floor was? It took a terrible beating with water, snow melting and mud being ground into it every day for 30 years. Not bad for being so old.
Cold, it came off in bits and pieces. No worries.
The tile came off in bits and pieces with this handy little thin-edged tool! Notice how the pattern of the old tile is still on the floor? Don't kid yourself, even if composite or vinyl self-stick tiles are tightly placed, they shrink a tiny bit, and water eventually works it's way into the cracks, staining the floor. Surprisingly, the sub floor plywood is still in good, solid condition.
A pile of tile. Rubble trouble. Unfortunately, it has to go to the landfill. The brittle old composite tile with it's old glue is not usable for anything. We do not have a recycling facility for such horrible stuff.
The old glue sure smelled awful! Outdoors it went!
Off to the landfill it will go on garbage day.
Tilly the Tall inspects the trash, but Ebony the Short didn't like that stinky stuff very much! Time to schmooze on that remaining nice cool snow instead.
We checked the plywood carefully to make sure it is still solid. If you have any doubt, poke it with a sharp penknife. The stains look terrible but the wood is still perfectly solid. I ran the belt sander with #80 paper over the seams to remove any remaining lumps of glue, broken, sticky bits of tile, or other old unidentifiable guck.
Next job is to cut off the door trim and door jambs to allow just enough room for the tile to fit under it neatly. You have to remember space for the thin set tile cement!
 |
| Trimming the doorjambs |
That handy little battery-powered oscillating Multi-tool made short work of that tough job! We used a short piece of board just the right thickness for a natural guide to get the right height above the floor, enough to allow for the thin set and new tile.
What a mess! Now the floor has to be vacuumed up perfectly again, and the new ceramic tile laid out. I know, this should have been called T for tough job instead of T for Tile and Tired!
The layout and installation of the new tile will have to wait until there's more energy available.
I think it's time for a snooze!
Is that incoming I hear?
